If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Na gut nachdem es eh schon Videos gibt das dBackup auch im OpenATV für die 900 läuft habe ich halt auch ein mit armhf gebautes ipk auf die erste Seite gemacht.
Nachdem die Leute schon recht effizient sind Ihren Flash vollzuballern (selbst auf den neuen Boxen mit eigentlich genug Platz), beginnt das Sofaflashen, wo man temporär das alten und das neuen Image im Flash hat (womit das Image maximal so groß wie der halbe Flash sein darf) langsam aber sicher an seine Grenzen zu stoßen.
Ich habe daher eine neue Version des swaproot binaries gemacht wo diese Einschränkung NICHT mehr gilt.
Allerdings habe ich keine Zeit und Lust das ausgiebig mit allen Backupformaten (tar.xz, tar.gz, tar,bz2, tar) durchzutesten - das ist mit der 0.66 vom dBackup jetzt EUER Job
Das Recovery Image und das Rescue Bios flashen sollte jetzt auch mit der 900 funktionieren, aber auch das ist noch ungetestet ...
weil ihr erstmal ohne das neue swaproot testen sollt.....
Wenn genug Leute berichten das normales flashen geht mache ich es wieder rein und wir testen kernel flashen Click here to enlarge
EDIT: > 100 downloads und fast kein Feedback ... auch gut, in der 0.67 ist das Flash kernel wieder aufgedreht, aber wenn was nicht klappt bitte nicht jammern ...
Sorularınızı forumda ilgili cihaz ve hangi konuda ise o bölümlerde yazıp sorun arkadaşlar özel mesajlarda teknik konular sorular sormayın lütfen açık alanda sorunki herkes yanıtlayabilsin daha çok paylaşım olsun başkalarıda aynı soruyu soracak faydalanabilsin..
Tüm paylaşımlar test ve bilgi amaçlıdır herhangi bir sorumluluk kabul edilmez..
[OE2.5] dBackup (arm) 2.4 r0 for DM900 Ultra HD TV 11.03.2019
WICHTIG:
das tar, pigz und xz binary ist ab Version 2.4 einen ZWINGENDE Abhängigkeit beim Installieren und keine Empfehlung mehr.
Wenn Euer Image diese also NICHT am Feed hat, werdet ihr diese von einem anderen Feed runterladen und manuell installieren müssen, bevor ihr dBackup installieren könnt.
IMPORTANT:
the tar, pigz and xz binary are starting with Version 2.4 a MANDATORY Dependency for the installation and no more just a recommendation. If your image does NOT have them on his feed, you will have to get them from another feed and install them manually, before beeing able to install dBackup
Thx @ gutemine
Sorularınızı forumda ilgili cihaz ve hangi konuda ise o bölümlerde yazıp sorun arkadaşlar özel mesajlarda teknik konular sorular sormayın lütfen açık alanda sorunki herkes yanıtlayabilsin daha çok paylaşım olsun başkalarıda aynı soruyu soracak faydalanabilsin..
Tüm paylaşımlar test ve bilgi amaçlıdır herhangi bir sorumluluk kabul edilmez..
Yorum yap