A lot of foreign friends have problem with latest 4k receiver because there is no mgcamd cccam etc working with arm based receivers only working cam is oscam so if u want to enter your Newcamd N lines or Cccam C lines to oscam it will be like this ....
With ftp connect to your solo 4k go inside etc/tuxbox/config or config_emu folder choose edit oscam.conf u will see there webif port and user pass like this
example port and user pass can be different ofcourse
[webif]
httpport = 8888
httpuser = admin
httppwd = admin
enter your webbrowser vusolo4kipnumber:8888 then enter username and password u will see the oscam web info panel enter Files-oscam.server
If u use Newcamd lines
#N: serverurlorip portnumber username password deskey
[reader]
label = Newcamd1
enable = 1
protocol = newcamd
key = 0102030405060708091011121314
device = serverurlorip,portnumber
user = username
password = password
group = 1
ident = 0100:000068 u can enter here your card idents
connectoninit = 1
if u use C line cccam server
#C: serverurlorip portnumber username password
[reader]
label = CCcam1
enable = 1
protocol = cccam
device = serverurlorip,portnumber
user = username
password = password
inactivitytimeout = 30
fallback = 1
group = 1,2
cccversion = 2.2.1
Then save and restart oscam from webpanel and see on oscam panel connected message on the right side of your entered lines thats all..
With ftp connect to your solo 4k go inside etc/tuxbox/config or config_emu folder choose edit oscam.conf u will see there webif port and user pass like this
example port and user pass can be different ofcourse
[webif]
httpport = 8888
httpuser = admin
httppwd = admin
enter your webbrowser vusolo4kipnumber:8888 then enter username and password u will see the oscam web info panel enter Files-oscam.server
If u use Newcamd lines
#N: serverurlorip portnumber username password deskey
[reader]
label = Newcamd1
enable = 1
protocol = newcamd
key = 0102030405060708091011121314
device = serverurlorip,portnumber
user = username
password = password
group = 1
ident = 0100:000068 u can enter here your card idents
connectoninit = 1
if u use C line cccam server
#C: serverurlorip portnumber username password
[reader]
label = CCcam1
enable = 1
protocol = cccam
device = serverurlorip,portnumber
user = username
password = password
inactivitytimeout = 30
fallback = 1
group = 1,2
cccversion = 2.2.1
Then save and restart oscam from webpanel and see on oscam panel connected message on the right side of your entered lines thats all..