- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Duyuru
Gizle
No announcement yet.
Smart Card Programmer
Gizle
Bu konu sabit bir konudur.
X
X
-
Cardmaster upgradeguide for Infinity
(Please notice: We'll no longer be able to deliver the cardmaster upgrade kit as of 1st of March 2003, this guide is therefore meant for customers who already have a kit).
This guide describes, step by step, how to upgrade an Infinity 1.3 programmer with the latest Cardmaster firmware (with support for both Silvercards, Funcards etc).
You'll need a the Cardmaster Upgrade Kit (contact us for availibility) a soldering iron, some tinsolder and a small flat screwdriver.
Step 1
Solder a 47 kOhm resistor (supplied in the upgrade kit) between the two points shown on the photo. Use either a leaded resistor,
or an SMD resistor, and make sure there's no shortcircuits between the 2 points.
Step 2
Remove the old firmwarechip with the screwdriver.
Step 3
Insert the new Cardmaster firmware chip, and make sure it's well seated in the socket. Notice the small marking on the chip, and make sure it's aligned correct.
Yorum yap
-
-
-
-
-
OTHER SMARTCARD PROGRAMMER
CARD WRITER 187
IC PROGRAMMER
JG PROGRAMMER
MASTER BURNER
PROMIM PROGRAMMER
Eklenen Dosyalar
Yorum yap
-
alp_21 Nickli Üyeden AlıntıSayın Ustalar Bende unıplat card yazıcı var bunula opus cart ı yükleyebilirmiyim?
Yorum yap
Yorum yap